Easy Heat AHB-019 Water Pipe Heating Cable 9′, 120Volt

Temperature-controlled cable runs straight along pipe and valves. held in place by application tape and plugs into grounded electrical outlet. Keeps water flowing down to -380. For odd lengths of pipe over 3/4 inches in diameter. we recommend two separate cables on opposite sides of the pipe with up to 3 feet of overrun at center of pipe run. Metal pipe requires 1/2-inch fiberglass insulation around cable. For plastic pipe. its recommended wrapping pipe with aluminum foil before cable installation. The traditional resistance cable produces a fixed amount of heat based on the electrical line feed. It comes with a built-in thermostat that switches the flow of electricity on and off based on temperature. 120 volts. 7 watts per foot.

Highlights:-

• Automatic thermostat
• 120 volt. 7 watts per ft.
• ON38 F and OFF 45 F
• 3-prong plug with ground braid
• For metal and all rated plastic pipe
• Cable can only be applied straight along the pipe
• Use on dry locations only
• Not for underground
• One year limited warranty
• UL & CSA listed
• Boxed
• 9′