You can’t beat a Drum Sander for removing planer knife marks and glue lines after panel glue ups while maintaining a consistent board thickness. These 24 in. Drum Sanders are the ideal size for finishing up after most planers and the dual drums allow a coarse and fine sanding in 1 pass, if desired. The G1066Z features a variable-speed feed rate and built-in amp meter to gauge workload. Every shop needs 1 of these.
- 5 HP, 220-Volt drum motor dri-voltes 2 aluminum sanding drums
- Handles stock up to 23-1/2 in. and 4-1/4 in. T
- Variable speed conveyor: 0 FPM to 20 FPM
- Surface speed of drum: 2300 FPM
- Hook and loop sandpaper 3 in. W
- Industrial rubber conveyor belt (similar to wide belt sander belts)
- Control panel with amp load meter
Specifications
- Maximum Speed (rpm): 3450
- Dust collection type: Port
- Tools Product Type: Power Tool
- Maximum feed rate (ft./min.): 20
- Amperage (amps): 25 A
- Variable Speed: Yes
- Color Family: Green
- Condition: New
- Power Tool Features: Variable Speed
- Bench & Stationary Tool Type: Drum Sander
- Portability: Stationary
- Cord Length (ft.): 8
- Voltage (volts): 220
- Product Weight (lb.): 389
- Reconditioned: No
- Table Length (in.): 0
- Belt length (in.): 176
- Belt width (in.): 3
- Product Height (in.): 44.5 in
- Product Depth (in.): 37 in
- Minimum feed height (in.): 0.125
- Table Width (in.): 0
- Maximum feed height (in.): 4.25
- Product Width (in.): 24 in
WARNING: This product can expose you to chemicals including arsenic, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov
Reviews
There are no reviews yet.